Tutorial 1
– Create new model
– Create grids
– Create model views
– Point creation
– Model footings
– Model columns
– Model beams
– Member offset and rotations
– Add baseplate, endplate, shear plate connections
– Copying members

Tutorial 2
– Set out and connect portal frame
– Model wall bracing
– Work with workplanes
– Create true plan views
– Model roof bracing
– Add bracing connections
– Model purlins
– Add purlin connections
– Add bridging

Tutorial 3
– 3D modelling techniques across multiple views
– Model holes manually
– Contour plate tool (hopper walls)
– Beam tool (hopper flange)
– Welding

Tutorial 4
– Construct angled points for stair setout
– Model PFC stair stringers and toeing direction
– Mitre joints
– Line Cut and Fitting tools
– Folded plate tread using Polybeam
– Polybeam corner chamfers

Tutorial 5
– Create baseplate connection manually
– Trim/extend column shaft with fitting
– Beam and contour plate tools (baseplate and stiffeners)
– Model holes manually
– Welding
– Create custom component
– Bolt Parts tool
– Polygon cut for notching and penetrations
– Manual beam bolting

Tutorial 6
– Model pipe truss
– Construct angled points for truss setout
– Use Endplate 144 connection with pipe
– Use Round Tube 23 for pipe-to-pipe cuts
– Add splices with split tool
– Splice plate component
– Create wrap-around drawings of notched pipe

Tutorial 7
– Apply learnings to full project
– Project setup: bolt grades, part/assembly prefixes
– Set out hip roof and jack rafters
– Create hip and custom apex connections
– Fitting 13 for trimming truss members
– Column/mullion under rafter connections
– Model numbering and checking
– Clash checking
– Run reports
– Model view representations

Tutorial 8
– Create GA drawings (marking plans)
– 3D perspective views
– HD bolt, floor, roof, purlin plans
– Elevations
– Assembly & single part drawings
– Drawing Wizards
– Drawing editing tools

Tutorial 9
– Manage drawings and revisions
– Revise model using checklist
– Re-numbering after changes
– Track changed marks
– Understand Tekla’s drawing flags
– Update and annotate revised drawings
– Use “Ready for Issuing” and “Issued” flags
– Check for new drawings
– Print drawings